Furuno FR-1908V-BB, Руководство по установке

Страница: 20 / 44

2. WIRING
2-6
2.2 Processor Unit
How to fabricate the power cable
1. Remove the armor of the cable and the vinyl sheath by 60 mm.
2. Remove the vinyl sheath 40 mm.
3. Remove the insulation of the cores 10 mm. Fix crimp-on lugs (FV5.5-4, yellow,
supplied) to the cores.
4. Peel the paint of the armor 40 mm for to make ground connection.
5. Cover the end of the armor with vinyl tape. Lay the section where paint was peeled
on the cable clamp on the cable entry side of the processor unit. Fasten the cable
clamp.
6. Fasten the crimp-on lugs to the terminal block.
DVI-D and USB cable
(5 m, to Monitor Unit)
RGB cable (option)
(to external monitor)
TTYCSLA, antenna, control
unit and RW-4864 cables
(For clamping positions,
see the sticker on the
reverse side of the top
cover.)
LAN cable
(to other radar or HUB switch)
Ship’s power
(DPYC-6, local supply)
Ground terminal
(IV-8sq., local supply)
Armor
Vinyl tape
DPYC-6
䠄
DC
䠅
60 mm
10
Peel paint (40 mm)
40