Furuno FI-70, Руководство оператора

Страница: 52 / 98

4. SYSTEM MENU
4-8
4.6 How to Set Up the IF-NMEAFI (Option)
The optional IF-NMEAFI is required when inputting data from analog NMEA
equipment to the FI-70. Set the IF-NMEAFI up as follows.
4.6.1 IF-NMEAFI menu settings
1. Access the [System] menu using the procedure outlined on page 4-1.
2. Press the
software keys to select [IF-NMEAFI], then press the function key.
3. [Select IF] is already selected, press the function key. A pop-
up window similar to the one shown on the right is displayed.
4. Press the software keys to select the appropriate IF-NMEAFI
unit, then press the function key.
5. Press the software keys to select [Category], then press the function key.
6. Press the software keys to select the category for the connected analog sensor,
then press the function key. The available options are listed below, with a brief
explanation.
• [Wind]: For wind sensor connection (FI-5001/L).
• [ST800/ST850]: For water temperature/speed sensor connection (ST-02PSB/
ST-02MSB)
• [Fuel]: For fuel tank gauge connection.
• [Fresh Water]: For fresh water tank gauge connection.
• [Waste Water]: For waste water tank gauge connection.
• [Live Well]: For live well tank gauge connection.
• [Oil]: For oil tank gauge connection.
• [Black Water]: For black water tank gauge connection.
7. If the selection at step 6 is neither [Wind] nor [ST800/ST850], the following four
menu items must also be set.
• [Resistance Full]: The resistance, in Ohms, when the tank is full.
• [Resistance Mid]: The resistance, in Ohms, when the tank is half full.
• [Resistance Empty]: The resistance, in Ohms, when the tank is empty.
• [Capacity]: The capacity of the tank.
8. Press the Menu/Back key twice to lose the menu.
IF-NMEAFI
Select IF:
Category:
Resistance Full:
Resistance Mid:
Ent
--------------------------
Ohm
Ohm
----------------
0hm
---------------
IF-NMEAF :000007
IF-NMEAF :000008