Furuno Felcom 30, Руководство по установке

Страница: 24 / 55

17
2.2 Installing the Above Deck Equipment (ADE)
Unpacking
Unpack the antenna unit carefully so as not to damage it. Check it for damage.
Mounting procedure
1. Place the antenna unit on the mounting base.
2. Fix the antenna unit to the mounting base with supplied fixing studs, nuts and washers.
3. Coat exposed nuts, fixing studs and washers with silicon sealant, to prevent electrolytic
corrosion. Also, coat all holes for radome base fixing bolts with silicon sealant.
4. As shown below, run a ground wire (local supply) between any one fixing stud and a
ground stud (local supply) welded to the mast.
Flat Washer
Spring Washer
Coat here with
silicon sealant.
13 mm Nut
10 mm Nut
Mounting Base
Fixing
Stud (4)
(supplied)
Mounting Base
T
Antenna
Unit
Ground stud
Ground wire
Ground wire
(fix to any one fixing stud)
Note:
Do not use a rubber gasket on the mounting base. The face of the mounting base
should be flat as possible (tolerance: within 2 mm of the horizontal plane).
If tolerance is more than 2 mm, insert a metal spacer between the antenna bottom
and the mounting base.
Attach electromagnetic wave caution labels
Labels which warn of electromagnetic waves are supplied with the installation materials.
Attach them to the following locations:
• Attach one to the radome mast where it can easily be seen.
• Attach other to a conspicuous location in any stairwell leading to the deck where the
antenna unit is installed.
www.reelschematic.com
www.reelschematic.com