Furuno FCV-288, Руководство оператора

Страница: 25 / 56

1. OPERATION
17
Data menu
This menu mainly sets up how to display data
input by external equipment.
[Data Box1(2)] : Show or hide the Data Box1,
Data Box2 indication, which appears below
the header info. You can select multiple indi-
cations in which case they are displayed alter-
nately every four seconds (default setting).
1. Select [Data Box1] and press the ENTER
key.
2. Select [Data Box1] and press the ENTER
key.
3. Select [On] and press the ENTER key.
4. Select a data and press the ENTER key.
5. Select [On] or [Off] and press the ENTER
key.
6. Repeat steps 4 and 5 to show or hide oth-
er items.
7. Select [Switching Cycle] and press the
ENTER key.
8. Select the amount of time (in seconds) to
show each data and press the ENTER
key.
9. Set the Data Box 2 similar to how you set
the Data Box 1.
[Bearing] : Select the bearing sensor. [True]
for gyrocompass, satellite compass;
[Mag](netic) for magnetic compass.
[Wind Spd/Dir] : Select the format of wind
speed and direction output from a wind sen-
sor, [True] or [Apparent].
[Trip Source] : Select the source for the trip
indication: Select [Own] to use the speed data
from the speed sensor connected to this unit,
or [NMEA] to use speed data from a naviga-
tor.
[Temp Source] : Select the source for the wa-
ter temperature indication: Select [Own] to
use the water temperature data from the wa-
ter temperature sensor connected to this unit,
or [NMEA] to use the water temperature data
from a navigator.
[Speed Source] : Select the source for speed.
Select [Own] to use the speed data from the
speed sensor connected to this unit, or
[NMEA] to use the speed data from a naviga-
tor.
[Trip Reset] : Select [Yes] to reset the trip dis-
tance to zero. Two beeps sound after the
completion.
Data Box1 display
Data Box2 display