Furuno FCR-2829W, Руководство по установке, Страница: 38 / 174

2. WIRING
2-4
5. Fold back the armor by 5 mm, then put it between washers.
6. Tighten the cable gland, and then cover the junction with putty for waterproofing.
7. Connect the cores to the connector plug TB803 by referring to the interconnection
diagram. Leave "slack" in the coaxial wire to prevent breakage.
Use the terminal opener to insert each core.
8. Confirm that all screws are tighten and all wirings are properly made. Confirm that
waterproofing gasket, bolts and tapping holes of antenna unit are coated with sil-
icone grease.
Waveguide connection at antenna unit
The signal cable entrance (cable gland) is located directly below the waveguide outlet.
If the waveguide is installed downward from the waveguide outlet position using an E-
bend waveguide, you may not be able to insert the signal cable into the cable gland.
To avoid this inconvenience, shift the waveguide run left or right using an H-bend
waveguide as shown below.
The E-bend and H-bend waveguides are contained in the waveguide materials set
22X-CW or 52X-CW.
Wiring for WAGO connector
Press downward.
Terminal opener
Wire
WAGO connector
Twist
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
MPYCY-19 cable
S901
03P9349
Connector
plug