Furuno FCR-2829W, Руководство по установке

Страница: 35 / 174

2-1
2. WIRING
2.1 Interconnection
Wiring consideration
To lessen the chance of picking up electrical interference, avoid where possible rout-
ing the signal cable near other onboard electrical equipment (radars, transmitting ra-
dio antennas, etc.) Also avoid running the cable in parallel with power cables. When
crossing with other cable, the angle should be 90° to minimize the magnetic field cou-
pling. The signal cable between the antenna and processor units is available in
lengths of 15 m, 30 m, 40 m and 50 m. Whatever length is used, it must be unbroken;
namely, no splicing allowed. Use the signal cable as short as possible to minimize at-
tenuation of the signal. The radar should be connected to an emergency power
source, as required by SOLAS II-1.
FCR-2829W
Radar
Processor unit
100-115 VAC/220-230 VAC
RW-9600
15/30/40/50 m
(Max.100 m)
DPYC-2.5
Junction Box
RJB-001*
Junction Box
RJB-001*
: Cable requires fabrication
*: If the cable run between the antenna unit and radar processor unit is more than 100m,
use Junction box RJB-001. However, the maximum length is 300m.
DSUB9P-X2 cable
5 m/10 m
Processor Unit
EC-3000
MPYC-7
or TTYC-1T
Radar Control Unit
RCU-025
Trackball Control Unit
RCU-026
100-230 VAC
100-230 VAC
DVI-D/D SINGLE LINK cable
5 m/10 m
Monitor Unit
MU-231
(FCR-28x9)
USB
memory
MOD-Z702 cable
GYRO
(SYNCHRO,
STEPPER, or
IEC61162-2)
RPU-013
HUB-3000
Sensor Adapter
or HUB-100
XH10P-XH2P cable
(2 m)
FR-FTPC-CY cable
100-230 VAC
GYRO, AIS
TTYCS-4
x2
GPS, LOG, E/S,
WIND, ALRM,
NAVTEX etc.
TTYCS-1Q
x6
5 m
(for USB)
30 m
USB
memory
x2
TTYC-10 cable
System fail, Power fail,
Normal close 1/2.
Normal open 1/2,
ACK IN
TB801
TB802
Antenna unit
Waveguide
WRI-84 (WRJ-9)
or
FR-9
For De-icer
TB803
100 VAC,
1ø
, 50/60 Hz
MPYCY-19
(Max. 30m)
RU-3305
110/115/
220/230 VAC,
1ø
, 50/60 Hz
Transceiver
unit
RTR-081
TB801
TB802
TB803