Furuno FCR-2139S-BB, Руководство по установке

Страница: 36 / 152

2. WIRING
2-10
• Other cables for optional units
Use TTYCS-1 or TTYCS-1Q (Japan Industry Standard cable) or equivalent. For de-
tails, see the appendix.
Connection of Sub-display
A conventional remote display and/or FCR-2107 series radar can be connected to
J617 and J 618 in processor unit as sub-display. However, the GAIN and STC controls
function differently depending on J617 and J618. Refer to the tablet to connect sub-
displays.
Port Conventional remote display FCR-2107 series radar
J617
(FULL-LOG) Overall gain Even if input video level is ad-
justed to 4 Vp-p, the gain is 8 dB
lower than that on the master ra-
dar. The gain is 8 dB lower than that on
the master radar.
GAIN control The GAIN control functions. The GAIN control does not func-
tion.
STC control The STC control functions. The STC control does not function.
60: Scrape off paint.
L
5
Shield
Armor
Clamp here by cable clamp.
Vinyl tape
After exposing cores,
wind shield around the armor.
6
L= Depends on equipment
connected. Measure at
the processor unit.
Wiring for Coaxial cable
CAUTION
Clamp shied with bracket.
Tighten conductor with screw.
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
Terminal opener
Wiring for WAGO connector
WAGO connector
Wire
Twist
Press downward.
Do not use crimp-on lug to prevent
contact resistance from increasing.