Furuno FCR-2107 series, Руководство оператора

Страница: 311 / 556

10. Route Planning
10-13
Dragging and dropping waypoint to new position
1. Place the cursor on Route in the status bar, click Plan to open the Plan Route dialog box then click the WPT tab.
2. Check Enable changes, then place the cursor on the waypoint you want to process.
3. Press and hold down the left button while rolling the trackball to move the cursor to a desired position. Keep the
button pressed down while you move the cursor and release it when the cursor is at desired position.
LAT LON Mode RAD/NM CH lim/m MIN/l\kn MAX/kn
WPT
WPT
WPT count
Delete WPT
Alerts
4. Drag and drop waypoint to new position (in this case waypoint number 9 is taken to a new position).
10.4.3 Changing other waypoint data
To change other data of a waypoint, such as name, steering mode, turning radius, min/max speed, do the following:
1. Place the cursor on a desired field and spin the scrollwheel to change data.
2. Push the scrollwheel to confirm changes.
10.4.4 Adding a new waypoint at the end of a route
There are two ways by which you can add a new waypoint at the end of a route:
•
Use the cursor and left button to define position of a waypoint.
•
Use the Insert after button in the WPT page.
To add a new waypoint by using the left button, do the following:
1. Place the cursor on Route in the status bar then click the Plan button to open the Plan Route dialog box. Click
the WPT tab to open the WPT page. Check Enable changes.
2. Place the cursor in the electronic chart area on the location desired for a waypoint then push the left button. The
waypoint is added at the end of route.
3. Modify data of added waypoint.