Furuno FB-3101, Руководство оператора, Страница: 20 / 56

3. USING THE SYSTEM
12
Adjusting the light
To increase the light intensity, press and hold the Dim

button .
To decrease the light intensity, press and hold the Dim

button .
To go directly to full light intensity, press both Dim buttons at the same time.
Note: The light always goes to full intensity if there is an event such as a Distress message, a fault
or the Test button is pressed.
You can always use the Dim buttons to dim the light again if you want to.
3.6 Configuring the System for Safety Voice
To configure the system for Safety Voice, consult your local dealer.
3.7 Testing the Safety Voice (Non-SOLAS) System
Apart from checking the displays of the Alarm Panel and the IP Handset as described in the pre-
vious section and testing the Alarm Panel itself as described in "Testing the Alarm Panel" on
page 11, a qualified technician can only test the Distress function for the total system.
To test the Distress function, consult your dealer.