Furuno FAR 3220, Руководство по установке

Страница: 70 / 245

2. WIRING
2-28
the supplied adhesive. Fasten the installation materials to each of the cover
bolts.
Note: If it is necessary to open the front cover after installing the DE-ICER kit, re-
move the de-icer power cable from the locking wire saddle shown in the following
figure then detach the cover slowly to prevent damage to the heater.
15. Reconnect the performance monitor connector (J807).
16.
Check that the gasket on the front and rear cover is seated properly , then
close the covers. The torque for the fixing bolts must be 28.0 N•m.
Note: For the de-icer specifications, take care not to hit the heater elements on
the chassis or radiator. If the heater hits something, unfasten the fixing screws for
the heater to adjust the position of the heater. Then fix the heater again.
2.5 Antenna Unit (S-band, TR-DOWN)
2.5.1 How to fabricate the cables
For how to connect the WAGO connector, see "WAGO connector" on page 2-5.
M5 screw coated
with adhesive M5 screw coated
with adhesive
Cover Bolt Cover Bolt
M5 screw
(Do not apply adhesive.) M5 screw
(Do not apply adhesive.)
Fixing Shaft Fixing Shaft
SD Heater
Fixing Plate SD Heater
Fixing Plate
FRONT FRONT
Remove the de-icer power cable from the locking
wire saddle to open the front cover.
Remove the de-icer power cable from the locking
wire saddle to open the front cover.