Furuno FAR-2137S, Руководство по установке

Страница: 15 / 130

1. MOUNTING
1-7
1.2 Monitor Unit
The monitor unit can be flush mounted in a console panel, or mounted on a desktop using
the optional accessories.
Note:
FAR-2137S-BB has no monitor unit. Prepare a suitable one locally.
Recommended monitor: SXGA (1280x1024), aspect ratio 5:4
Mounting considerations
When selecting a mounting location, keep in mind the following points:
•
Select a location where the display unit can be viewed conveniently and where the
screen can be viewed while facing towards the bow.
•
Locate the unit out of direct sunlight and away from heat sources because of heat that
can build up inside the cabinet.
•
Locate the equipment away from places subject to water splash and rain.
•
Leave sufficient space on the sides and rear of the unit to facilitate maintenance.
•
A magnetic compass will be affected if the monitor unit is placed too close to the
magnetic compass. Observe the compass safe distances on page ii to prevent deviation
of a magnetic compass.
Mounting procedure
Flush mounting
Follow the procedure below to mount the monitor unit in a console panel.
1. Make cutout in mounting location referring to the outline drawing shown below.
2. Insert the monitor unit to the hole and fix it by four tapping screws (6x30).
3. Attach panel hooks near the fixing holes (upper two locations). These are used to pull
out the monitor unit from a console panel for servicing.
4. Attach four panel covers to the fixing holes.
(79)
454
534
4-
φ
8
FIXING HOLES
Monitor unit MU-201CR
490
420
296
506
4-FIXING HOLES
30 80
(For FAR-2137S)
±
1
±
1
506
±
1
296
±
1