Furuno FAR-1416, Руководство оператора

Страница: 68 / 226

1. OPERATIONAL OVERVIEW
1-54
1.38.2 How to change PI line bearing and interval
1. If not already displayed, show a PI line, referring to paragraph 1.38.1.
2. Place the arrow on the PI line orientation in the [PI Line] box.
3. Rotate the scrollwheel to adjust the PI line bearing, between 000.0° to 359.9°.
Enter a negative value to move the PI line to the opposite side of the PI line pass-
ing through the own ship position.
4. Place the cursor on the PI line interval.
5. Rotate the
scrollwheel to change the PI line interval.
1.38.3 How to change the PI line bearing reference
PI line bearing reference can be relative to own ship’s heading (Relative) or refer-
enced to North (True) as below.
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button .
3. Select [PI LINE], then press the left button .
4. Select [PI LINE MODE], then press the left button .
5. Select [REL] or [TRUE] as appropriate, then press the left button .
6. Close the menu.
1.38.4 How to change the PI line orientation
PI lines orientation can be selected from parallel or perpendicular. This function is
available when [SET ALL PI LINE] in the [PI LINE] menu is set for other than [1].
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button .
3. Select [PI LINE], then press the left button .
4. Select [PI LINE MODE], then press the left button .
5. Select [HORI.], [VERT.] or [BOTH] as appropriate, then press the left button .
6. Close the menu.
PI1
ON 035.2° R
10.00NM
PI line orientation
PI line interval
0° 0° 0°
: Base line
Horizontal Vertical Both side