Furuno CSH-5LMARK-2, Руководство по установке

Страница: 29 / 86

2. WIRING
2-3
2.2 Hull unit/Pre-amplifier Unit
2.2.1 Running transducer cable
Excessive stress should not be placed on the transducer cables (12 pcs.) during raise/
lower operation. Follow the procedure below to run the cables.
1. Fix the 12 transducer cables with the cable clamp [A].
Cable clamp (1)
2. Temporarily fix cable clamp [B]. Note the positions of cable in clamps [A] and [B]
as shown below.
Cable clamp (2)
3. Adjust the cable length between the cable clamps [A] and [B] as follows.
4. Adjust slack of the other ten cables so that it becomes the same as the ones ad-
justed at step 3. Tighten the cable clamps [A] and [B].
600 mm Travel type 400 mm Travel type
Length of cable between [A] (a) and [B] (a) 660 mm 580 mm
Length of cable between [A] (u) and [B] (u) 690 mm 610 mm
Cable clamp [A]
Raise/lower drive
assembly
Cable clamp [B]
Raise/lowershaft
Ex) The cable which is fixed at
(a) of the clamp [A] should be
wired to (a) of the clamp [B].
Cable
clamp [A]
Cable clamp [B]