Furun 406080A-FUR, Руководство оператора

Страница: 5 / 40

iii
Safety instructions
The following general safety precautions must be observed during all
phases of operation, service and repair of this equipment. Failure to
comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture and
intended use of the equipment. FURUNO assumes no liability for the
customer's failure to comply with these requirements.
GROUND THE EQUIPMENT
To minimise shock hazard, the equipment chassis and cabinet must be
connected to an electrical ground and the cable instructions must be
followed.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the equipment in the presence of flammable gases or
fumes. Operation of any electrical equipment in such an environment
constitutes a definite safety hazard.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove equipment covers. Component
replacement and internal adjustment must be made by qualified
maintenance personnel. Do not service the unit with the power cable
connected. Always disconnect and discharge circuits before touching
them.
OBSERVE MARKED AREAS
Under extreme heat conditions do not touch areas of the
unit that are marked with this symbol, as it may result
in injury.
COMPASS SAFE DISTANCE
Minimum safety distance: 30 cm (standard), 20 cm (steering)
DISCONNECT THE AC POWER BEFORE REMOVING THE
PROTECTIVE LID
Hazardous voltage exists behind the protective lid.
Failure to comply with the rules above will void the warranty!
Warning! Never insert or remove a power supply while its
power switch is in the On (|) position. Make sure the
power switch is Off (O) first.