10
Connections
Wiring Diagram
Refer to accessories page for planning connections.
WARNING:
The wall plate should be turned off while connecting cables.
Connect the cables from the antenna to distribution wall plate and to the FM radio
(AM Radio needs to connect the FM/AM antenna from the rooftop unit). Connect the
power cables from the distribution wall plate according to the diagram below.
ON OFF
Satellite
TV 1
ON = TV
OFF = Cable
TV ANTENNA
TV 2
CABLE IN
TV 1
TV 2
Cable Input Plate
(Not Supplied)
Distribution Wall Plate
(Sold Separately)
Coaxial Cable
(Sold Separately)
Coaxial Cables
(Sold Separately)
Coaxial Cable
(Sold Separately)
Satellite Antenna
(Not Supplied )
Coaxial Cable - Black
(Sold Separately)
AM/FM Receiver (Not Supplied)
Red Wire
+12V DC
Black Wire
Ground
Antenna Extension
Cable - White
(Sold Separately)
Ceiling Mount Bracket
Network Cable Connector
Network Cable Connector
Red +12V DC
Black GND
(Black)
(Blue)
(Yellow)
AM/FM ANTENNA
Vehicle’s Roof
Self-tapping Screws
Antenna Base
TV Antenna
TV/FM ANTENNA
Testing the Power Supply
Make sure your TV set is working properly.
●
Disconnect the cable from the antenna jack on the power supply and check for
+12VDC. If +12VDC is present, there is a cable problem connecting the power
supply to the antenna, repair/replace the cable. If +12VDC is not present at the
antenna jack, be sure the indicator light is ON. If not, check the polarity of the red/
white wires and the +12VDC source.
*
*
The outline of the antenna base equipped with FAN73B7C-BL3 is slightly different.
