English
CCD-0005506 Rev: 08-16-22
- 9 -
Oven Installation Continued
13. After attaching the gas line and the electrical connection,
finish sliding the range into the cabinet opening.
14. Verify the oven is level from side to side and front to rear.
15. Open the oven door and securely fasten the oven in place with
four screws (not provided). (Fig. 7)
16. Securely fasten the rear of oven to the pre-installed wood piece
(Fig. 1) in place with two screws (not provided). (Fig. 7)
Wooden P
ieces
Wooden P
ieces
Fig. 7
Rear Decorative Panel Installation
Align the arrows from the rear decoration panel with the arrows
on the rear mounting tabs on the back of the range and push up
against the wall behind the range. Use 2 screws (not provided) and
attach to the pre-installed wood piece from Fig. 1.
NOTE:
Before fastening the screws, align the two arrows, one is on
the rear range tab, one is on the decorative panel tab. (Fig. 8)
Fig. 8
Aligned
Ventilation Installation
1.
Loosen the 4 screws on the rear of the cooktop and leave a
gap of 3 to 4 mm. (Fig. 9)
3~4mm
Fig. 9
2. Align the 2 plastic guides located on the each side of the vent
cover and insert them into the groove of the rear decorative
panel. (Fig. 10)
3. Place the vent panel onto the rear decorative panel with
the VENT LOUVERS towards the front. Slide the vent panel
along the groove towards the wall until it is directly behind the
cooktop. (Fig. 10)
4. The mounting slots will slide under the 4 screw heads when
the vent panel is correctly positioned. Then tighten the four
screws to secure the vent panel to the cooktop. (Fig. 10)
2
side plastic pilla
r
1
3
Fig. 10
Aligned
Plastic Guide
VENT LOUVERS
Grate Installation
Align the grate pins with the holes in the cooktop. (Fig. 11)
NOTE:
Ensure to insert each burner grate pin into the right hole.
After the installation ensure the burner grates surface is flat and
stable and the burner is aligned with the grate's opening correctly.
Fig. 11
Grate Pin
Front Decorative Panel Installation
1.
Align the rubber plug into the bottom of the range to fix the
front decorative panel. (Fig. 12)
2. Secure the front panel and use 2 screws (not provided) on the
front of the range. (Fig. 12)
1
2
Fig. 12
Rubber Plug
