Field
Description
made, your device uses a default netmask.
•
(%
: The lower the value, the higher the priority of the
route (range of values
...
). The default value is
.
IP Assignment Pool
Only if IP Address Mode =
0&&
Select IP pools configured in the WAN->In Dialup->IP
Poolsmenu. If an IP pool has not been configured here yet, the
message
* )
appears in this field.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed.
The default value is
'
.
Maximum Number of
Dialup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
to
.
The default value is
.
Usage Type
If necessary, select a special interface use.
Possible values:
•
-
(default value): No special type is selected.
•
1/ /)
: The interface is used for incoming dialup con-
nections and callbacks initiated externally.
•
(/!3& 1/ /)"
: The interface is defined as
multi-user connection partner, i.e. several clients dial in with
the same user name and password.
Authentication
Select the authentication protocol for this PPTP partner.
Possible values:
•
0
(default value): Only run PAP (PPP Password Authentic-
ation Protocol); the password is transferred unencrypted.
Funkwerk Enterprise Communications GmbH
17 WAN
bintec Rxxx2/RTxxx2
281
