Funkwerk DECT80, Руководство по эксплуатации, Страница: 71 / 84

69
Troubleshooting guide
If your system should not "behave" as it is supposed to, refer first to the following table to attempt to
resolve the problem yourself.
Problem
After pressing the Call key
there is no audible dial tone; the
line for dialing is not seized
With PABX-systems:
No call, or call to wrong number
after dialing from the memory
Menu shows:
„Searching base"
Menu shows:
„Handset not Registered"
Possible cause
The connecting cord connec-
tors for the base station are not
plugged in
The power supply unit connec-
tors for the base station are not
plugged in properly
The line for dialing is occupied
by another handset.
Exchange code not entered
Base station out of range
Base station not connected to
the mains supply
Handset not registered
Fault Remedy
Check the connector at the
base station and at the phone
jack (may have to pull it out and
plug it back in)
Check the connector at the
base station and at the 230 V
power supply (may have to pull
it out and plug it back in)
Wait until the line is free for
dialing.
Enter exchange code (see page
61)
Reduce the coverage range
Connect the base station to
power
Handset log-in (see page 57)