User´s manual
- 1 -
FUM - 1240CBP // FUM - 2420CBP
FUM – 1240CBP // FUM – 2420CBP
3 stage battery charger
User’s manual
IMPORTANT SAFETY INSTRUCTIONS
WARNING Shock and Energy Hazards
Be sure to read the safety guidelines and pay attention to
all cautions and warnings throughout the installation
procedure.
The installer is responsible for ensuring compliance with
the installation codes for your particular application.
Disconnect all sources of AC and DC power before
proceeding
Especifications
Model FUM-1240CBP
FUM-2420CBP
Output current
40A
20A
Charging type
3 stage
Bulk stage
14.5V (±0.5V), 40A
29.0V (±1.0V), 20A
Absortion stage
14.5V (±0.5V), 40A~4A
29.0V (±1.0V), 20A~2A
Float stage
13.6V @ min. 0.5A (depends on battery
status)
27.2V @ min. 0.25A (depends on battery
status)
AC input voltage
115V (90~135V) // 230V (180~270V)
Frequency
50 / 60Hz
Charger efficiency
85%
Recommended battery type and size
Lead-acid batteries, 250Ah and up
Remote control
Yes
Over load protection
Yes
Over temperature protection
Yes
Output reverse protection
Fuse blow
Operating temperature
0ºC ~ 30ºC
Storage temperature
-25ºC ~ 70ºC
Battery connection
1 positive terminal, 1 negative terminal
Dimension (L x W x H) mm
380 x 179 x 82
Net weight (Kg)
4.5
AC input cable
Yes
Precauciones de seguridad
1.
Do not expose the charger to rain, snow, spray, or bilge water. To reduce risk of fire hazard, do not cover or obstruct the
ventilation openings. Do not install the charger in a zero-clearance compartment. Overheating may result.
2.
The charger is designed to be permanently connected to your AC and DC electrical systems.
3.
Before using the charger, read all instructions and cautionary markings on the charger, the batteries, and all appropriate sections
of this guide.
4.
Use only attachments recommended or sold by the manufacturer. Doing otherwise may result in a risk of fire, electric shock, or
injury to persons.
5.
Do not disassemble the charger. Attempting to service the unit yourself may result in a risk of electrical shock or fire. Internal
capacitors remain charged after all power is disconnected.
6.
The charger must be provided with an equipment-grounding conductor connected to the AC input ground.
7.
To reduce the risk of electrical shock, disconnect both AC and DC power from the charger before attempting any maintenance
or cleaning or working on any circuits connected to the charger. Turning off controls will not reduce this risk.
8.
Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any.
9.
To avoid a risk of fire and electric shock, make sure that existing wiring is in good condition and that wire is not undersized. Do
not operate the charger with
damaged or substandard wiring.
ON/OFF SWITCH
Charging Status
Remote Control
AC Input
