When relamping, only use lamps specified in the exit sign. Using other lamp types may result in unsafe conditions.
PLEASE READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR SAFETY
6. Use caution when handling batteries.
8. Servicing of this equipment should be performed by qualified service personnel only.
1.
All electrical connections must be in accordance with local codes, ordinances and the National
3. Do not mount near gas or electric heater.
9. Do not let power cords touch hot surfaces.
4. Equipment should be mounted in location and at heights (Max: 7ft) where it will not be readily subjected to
tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
7. Do not use this equipment for anything other than the intended use.
SAVE THESE INSTRUCTIONS
Page 1 of 2
20
-
Rev A
18 783
Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060.
Specifications subject to change without notice.
[email protected] www.fulham.com
Electric code.
2. Do not use outdoors.
Choose your mounting configuration (Side, Top, or Back Mount). Then plug the remaining holes with the
appropriate color plugs.
1. Secure the canopy bracket to the dependent object, such as the wall, ceiling, and so on.
2. Open the ALUMINUM cover.
3. Lock the ALUMINUM box and canopy with the screws.
4. Outlet the AC input leads (RED, BLACK, WHITE) from the ALUMINUM box and canopy’s center hole, connect
5. Lock the canopy into the canopy bracket with screws, then insert the battery wire terminal into the two pin male.
GENERAL INSTALLATION
GUIDELINES FOR
EMERGENCY EXIT SIGN
(FHEX24)
the AC input leads to AC power supply leads, connect the RED lead to a 277VAC power supply and the
BLACK lead to a 120VAC power supply, WHITE lead to ground.
Battery in the unit may not be fully charged. After electricity is hooked up to unit, let the battery charge up for at least
24 hrs. The normal operation of the unit should take effect.
10. Before wiring power supply, turn off electricity at fuseof circuit breaker.
6. Snap the ALUMINUM cover.
