EN
27
19 - Solving Operational Problems
Before contacting service, check the following to avoid unnecessary service charges.
PROBLEM
PROBLEM SOLVING STEPS
The oven display stays OFF
Turn off power at the main power supply (fuse or breaker box). Turn breaker back on. If
condition persists, call an authorized service center.
Cooling fan continues to run after
oven is turned off
The fan turns off automatically when the electronic components have cooled sufficiently.
Oven light is not working properly
Replace or reinsert the light bulb if loose or defective. See Page 17. Touching the bulb
with fingers may cause the bulb to burn out.
Oven light stays on
Check for obstruction in oven door. Check to see if hinge is bent or door switch broken.
Also ensure function knob is turned to the ‘OFF’ position.
Cannot remove lens cover on light
There may be a soil build-up around the lens cover. Wipe lens cover area with a clean
dry towel prior to attempting to remove the lens cover.
Excessive moisture
When using Bake mode, preheat the oven first. Convection Bake and Convection Roast
will eliminate any moisture in oven (this is one of the advantages of convection).
Porcelain chips
When oven racks are removed and replaced, always tilt racks upward and do not force
them to avoid chipping the porcelain.
Ignition will not operate
Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
Has a household fuse been blown or
has the circuit breaker been tripped?
Replace the fuse or reset the circuit.
Surface burners will not operate
Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
Has a household fuse been blown or
has the circuit breaker been tripped?
Replace the fuse or reset the circuit.
Surface burners will not operate
Is this the first time the surface burners
have been used?
Turn on any one of the surface burner knobs to release air from the gas lines.
Is the control knob set correctly?
Push in knob before turning to a setting.
Are the burner ports clogged?
See “Super Sealed Surface Burners” section.
Surface burner flames are uneven yellow and/or noisy
Are the burner ports clogged?
See “Super Sealed Surface Burners” section.
Are the burner caps positioned
properly?
See “Super Sealed Surface Burners” section.
Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician.
Surface burner makes clicking noises
Is the burner wet?
Let it dry.
Is the cap and gas spreader
positioned correctly?
Make sure the alignment pins are properly aligned see “Super Sealed Surface Burners”
section.
Is the cooking vessel much larger
than the allocated grate space?
Remove vessel temporarily, if clicking ceases and then returns when putting the vessel
back, it is due to the oversized vessel. You can still continue to cook with the vessel but
the clicking will continue until cooking is complete.
Содержание Accento F4PGR304S2
