Fukuda DYASCOPE 8000 Series, Руководство по эксплуатации

Страница: 224 / 349

12-12
Chapter 12 Printing To Start/Stop the Printing
Alarm Printing, Periodic Printing
When the set condition is met, alarm/periodic printing will automatically start/stop.
The measurement value at alarm occurrence (at about 7 seconds point) will be printed for alarm printing.
Example of Alarm Printing
The measurement value at the beginning of the waveform (at the bed ID, channel ID display area) will be printed for
periodic printing.
Example of Periodic Printing
Remote Printing
When the [Print] key of the bedside monitor or [EVENT] key of the telemetry transmitter is pressed, remote printing
can be performed on the recorder unit (HR-800) connected to this equipment.

Waveform Remote Printing from the Wired Bedside Monitor
1
Press the [Print Start/Stop] key on the bedside monitor.
 Printing will be performed on the recorder unit of this equipment.
 If more than one central monitors are connected to the network, printing will be performed on the central
monitor with the smallest central ID.
 The printing will be performed according to the printing setting on the bedside monitor. The printing setting
on the central monitor will not be effective.
 For the patient ID, maximum of 10 digits will be printed.
NOTE
 [Central] should be selected as output printer for waveform printing on the bedside
monitor.

Graphic Remote Printing from the Wired Bedside Monitor
1
Press the [Print] key on the review data screen (ex. graphic trend).
 Graphic printing will be performed on the recorder unit of this equipment.
 The printing will be performed according to the printing setting on the bedside monitor.
NOTE
 [Central] should be selected as output printer for graphic printing on the bedside monitor.