Fukuda DYASCOPE 8000 Series, Руководство по эксплуатации

Страница: 29 / 349

ix
Safety Precautions for Using the Equipment
wrong group may occur.

The operation cannot be guaranteed if connected to improper TCP/IP network. When changing the network
setting, contact your nearest service representative. When connecting to an existing network, follow the
instruction of the network administrator.
 Make sure not to duplicate the IP address for DS-8900 System, laser printer, and the server.

As this system does not support DHCP (Dynamic Host Configuration Protocol) IP address, set the IP address
excluded at DHCP if DHCP server is used.

When a network setting is changed and [Regist] key is pressed, a warning message will be displayed. All the
operation controls will not be possible until the system is restarted.
Warnings about the Alarm
 The ventilator alarm on this monitor should be used as supplementary function. Check the patient's condition,
ventilator alarm sound and message occasionally.
 Depending on the bedside monitor type and software version, the ventilator alarm factor may not be transmitted
to the central monitor.
For details of the bedside monitor type and software version, refer to your nearest service representative.
 If the upper/lower alarm limit of the individual parameter is set to OFF, alarm will not generate even if the
individual parameter alarm is set to ON. Pay attention when setting them OFF.
 During monitor suspend condition or alarm suspend condition, all the alarms will not generate even if the
parameter alarm is set to ON. Also, the alarms will not be stored as recall events. Check the patient's condition
frequently.
 If [Displayed Data] is selected for "Numeric Data External Output" on the bedside monitor, the alarm for the
parameter not displayed on the bedside monitor will not generate on the central monitor.
Make sure to display the parameter on the bedside monitor if alarm monitoring on the central monitor is
required for that parameter.
 When a parameter monitored on a bedside monitor or telemetry transmitter is in a connector-off condition, the
numeric data and waveform for that parameter will not be displayed on the central monitor. Also the alarm will
not generate for that parameter. Make sure that the connectors are securely connected.
 If the parameter is not selected for the "HR/PR Alarm Source" (ECG/SpO
2
/BP) on wired bedside monitor, the
alarm for that parameter will be set to OFF on this equipment.
 When "Chk TLM Receive" or "Chk DS-LAN Comm" is displayed, alarm will not function.
 If the "Alarm Judgment" for "During Lead OFF" is set to OFF, HR alarm and arrhythmia alarm will not be
generated at lead-off condition. If this condition is left unresolved, a sudden change of the patient may not be
noticed. Take prompt action when the lead-off condition is detected.
 Some delay may occur until the alarm generated on the bedside monitor is displayed on the central monitor.
 The alarm generation will differ for the bedside monitor, telemetry transmitter, and central monitor depending
on the communication specification (wired or wireless). Read the operation manual thoroughly before setting
the alarm.
 Do not assess the patient's condition only by the alarm generated on this equipment. If the alarm is set to OFF
or if low priority is set for the alarm, the alarm condition of the patient may not be noticed.
 If an alarm generates, check the patient's condition first and ensure the safety. Depending on the alarm, take
appropriate measures to remove the problem. If the problem lies with the alarm setting, set the alarm properly.
 During monitoring, set the alarm volume according to the surrounding environment so that the alarm sound can
be always recognized.
 Use only the spare parts specified for this equipment. Otherwise, proper function cannot be executed.
 For quality improvement, specifications are subject to change without prior notice.
 The maintenance and internal switch setting will be performed by our service representative. Users should not
WARNING
CAUTION