Fukuda Denshi IB-7300, Руководство по обслуживанию

Страница: 48 / 146

Connecting the Power Supply Cable
Connect the Input Box to the AC power source.
Connect the accessory power cable (CS-18 or CS-24) to the hospital grade outlet with ground
terminal.
When the power cable is connected and the power supply switch is turned ON, the main power
supply indicator on the front side will light to notify that the AC power is supplied.
W A R N I N G
Use only the accompanying 3-way AC power cable. Use of other
cables may result in electric shock to the patient and the operator.
The power cable CS-18 must be connected to AC 100-240V outlet.
The power cable CS-24 must be connected to AC 100-120V outlet.
Do not use multi-tap.
When using multiple ME equipment simultaneously, perform
equipotential grounding to prevent potential difference between the
equipment. Even a small potential difference may result in electric
shock to the patient and the operator.
N O T E
Equipotential Grounding
When connecting multiple devices, electrical potential difference may be
generated between the devices. This may result in electric shock to the
patient connected to these devices. Pay special attention for use in the
operating room, ICU, CCU, Cardiac Catheter Laboratory, and
Cardiovascular X-ray room. To avoid such electrical potential difference,
use the accessory ground cable to connect each device’s equipotential
terminal to the same ground terminal. This is called equipotential
grounding.
CS-18
Power Supply LED
Lights when the AC power is supplied.
When the Input Box is turned ON, and display unit is turned OFF: Orange
When the display unit is turned ON: Green
The light turns off when the AC power is not supplied.
Power Supply Connector
3
－
9