Fukuda Denshi HS-8000 Series, Руководство по обслуживанию

Страница: 15 / 132

C A U T I O N
z BP Monitoring
y The zero balance procedure is required for the following case.
・
When starting the measurement.
・
When the position of the heart has changed due to body movement.
・
When the transducer position has changed.
・ When measuring for a long period of time and there is a possibility of
measurement error due to change in ambient temperature, etc.
・ When a connector is connected / disconnected, or a transducer is replaced.
z CO
2
Monitoring
y On the DS-8500 system, when the Multigas Unit MGU-800 series is used, CO
2
measurement by the GAS Unit which is connected to the HS-8000 series (for
example the Capnostat 5 using HPD-800) cannot be performed.
y
The disposable airway adapter should be opened just before use. Do not sterilize
it or it will become unusable .
y Do not reuse the disposable airway adapter.
y Do not sterilize the reusable airway adapter using autoclave methods.
z CO
2
Monitoring by Gas Unit I/F HPD-800
y
The airway adapter should be attached with the thicker side facing to the patient.
If attached oppositely, it may damage the CO
2
sensor or airway adapter.
z Temperature Monitoring
y Do not reuse the probe cover. Use it for a patient only and dispose it after using
it.
z Maintenance
y Clean the equipment and relay cables frequently so stains can be removed
easily.
y To prevent injury, it is recommended to wear gloves when cleaning the
equipment.
y Do not allow liquids or cleaning solution to enter the equipment or connectors.
y Do not use organic solvents, thinner, toluene or benzene to avoid damaging the
resin case.
y Do not polish the housing with abrasive or chemical cleaner.
y When sterilizing the entire room using a spray solution, pay close attention not to
have liquids get into the monitor or connectors.
y Use only neutral detergent to clean the housing. Do not use chemical cloth, scrub
brush, abrasive, polishing powder, hot water, volatile solvent and chemicals
(cleanser, thinner, toluene, benzine, benzol, and synthetic detergent for house
and furniture), or sharp-edged tools. The surface resin coating may be damaged,
resulting in discoloration, scratches, and other problems.
y Do not open the housing.
y
Avoid alcohol or other liquids from getting into the device.
y If you accidentally wet the device, dry it completely and verify it operates safely
before usage.
y Replace the periodic replacement parts periodically as specified.
Precautions for Use of SpO
2
Sensor
C A U T I O N
Burn Risk in Using SpO
2
Sensor
In SpO
2
monitoring, always use the sensor/relay cable (patient cable) specified by
Fukuda Denshi. If any other sensor/relay cable (patient cable) is used, a high
temperature rise of the sensor may place the patient in danger of burns.
xi