Fujitsu SPARC M10-4, Руководство по обслуживанию

Страница: 268 / 514

Table 13-2 Maintenance flow
Details of update process Replacement Expansion Reduction
1 Pre-check 13.3 13.3 13.3
2 Preparation 13.4 13.4 13.4
3 Removing a PCIe card or the filler for a
PCIe card
13.5 13.5 13.5
4 Installing a PCIe card or the filler for a
PCIe card
13.6 13.6 13.6
5 Restoring the system 13.7 13.7 13.7
13.2.3 Precautions for replacement
Note the following points when replacing PCIe cards.
■
For active maintenance by PHP, a multipath setting is necessary depending on the
use of the PCIe cards.
13.2.4 Precautions for installation
Note the following points when performing PCIe card expansion.
■
Set a multipath depending on the use of the PCIe card when performing active/hot
maintenance or active/cold maintenance with PHP.
■
If you are performing PCIe card expansion, remove the filler for the PCIe card
from the PCIe card cassette.
■
Keep the removed filler because it will be needed if PCIe card reduction is
subsequently done.
13.2.5 Precautions for removal
Note the following points when removing PCIe cards.
■
Set a multipath depending on the use of the PCIe card when performing active/hot
maintenance or active/cold maintenance with PHP.
■
If you are removing a PCIe card, attach the filler for the PCIe card after removing
the PCIe card from the PCIe card cassette.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 244