Fujitsu SPARC Enterprise T2000, Руководство по обслуживанию, Страница: 123 / 174

Chapter 5 Replacing Cold-Swappable FRUs 5-17
■
If the fault was detected by the host and the fault information persists, the output
will be similar to the following example:
■
If the
showfaults
command does not report a fault with a UUID, then you do
not need to proceed with the following steps because the fault is cleared.
11. Run the
clearfault
command.
12. Switch to the system console.
13. Issue the
fmadm repair
command with the UUID.
Use the same UUID that you used with the
clearfault
command.
5.2.5 Removing the System Controller Card
Caution –
The system controller card can be hot. To avoid injury, handle it carefully.
1. Perform the procedures described in Section 5.1, “Common Procedures for Parts
Replacement” on page 5-1 .
2. Locate the system controller card.
See Appendix A for an illustration of the servers FRUs that shows the system
controller card.
3. Push down on the ejector levers on each side of the system controller until the
card is released from the socket.
sc> showfaults -v
ID Time FRU Fault
0 SEP 09 11:09:26 MB/CMP0/CH0/R0/D0 Host detected fault, MSGID:
SUN4U-8000-2S UUID: 7ee0e46b-ea64-6565-e684-e996963f7b86
sc> clearfault 7ee0e46b-ea64-6565-e684-e996963f7b86
sc> console
# fmadm repair 7ee0e46b-ea64-6565-e684-e996963f7b86