Fujitsu SPARC Enterprise T2000, Руководство по установке, Страница: 54 / 88

28 SPARC Enterprise T2000 Server Installation Guide • April 2007
Use this port for server management. This port is needed to set up the SC network
management port, as detailed in
“Enabling the System Controller Network
Management Port” on page 37 .
Note –
Use the SC serial management port only for server management. It is the
default connection between the system controller and a terminal or a computer.
Caution – Do not attach a modem to this port.
●
Connect a Category 5 cable from the SC serial management port to the terminal
device.
When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.
▼
To Connect the SC Network Management Port
The SC network management port is marked NET MGT. It is the RJ-45 port above
the rear USB ports.
FIGURE 2-18
System Controller Network Connection
●
Connect a Category 5 cable from your network switch or hub to the Network
Management Port.
NET MGT