Fujitsu SPARC Enterprise T2000, Руководство администратора, Страница: 31 / 98

Chapter 1 Configuring the System Console 9
You can assign the network management port a static IP address or you can
configure the port to obtain an IP address using the Dynamic Host Configuration
Protocol (DHCP) from another server. The network management port can be
configured to accept connections from Telnet clients or SSH clients, but not both.
Data centers frequently devote a separate subnet to system management. If your
data center has such a configuration, connect the network management port to this
subnet.
Note –
The network management port is a 10/100 BASE-T port. The IP address
assigned to the network management port is a unique IP address, separate from the
main SPARC Enterprise T2000 server IP address, and is dedicated for use only with
the ALOM CMT system controller.
▼
To Activate the Network Management Port
1. Connect an Ethernet cable to the network management port.
2. Log in to the ALOM CMT system controller through the serial management port.
For more information about connecting to the serial management port, see
“Accessing the System Controller” on page 7 .
3. Type one of the following commands:
■
If your network uses static IP addresses, type:
■
If your network uses Dynamic Host Configuration Protocol (DHCP), type:
4. Type one of the following commands:
■
If you intend to use Secure Shell (SSH) to connect to the system controller:
sc> setsc if_network true
sc> setsc netsc_ipaddr
ip-address
sc> setsc netsc_ipnetmask
ip-netmask
sc> setsc netsc_ipgateway
ip-address
sc> setsc netsc_dhcp true
sc> setsc if_connection ssh