Chapter 5 Connectors
UG-910097-11
- 22 -
© Fujitsu Semiconductor Europe GmbH
J4 pin no.
Description
1
5V
2
Video Input Signal
3
GND
Table 17. Video Input Header J4: Pin Description
5.5 MCU Pin Headers (X4-X11)
All MCU pins besides the clock pins (83, 84, 171, 172), the C-pins (20, 73, 124) and the
DEBUGIF pin (103) are connected to the headers X4 to X11 as the following table shows.
Connector
MCU Pins
Connector
MCU Pins
X4 (1 - 26)
1
– 26
X8 (1 - 26)
105
– 130
X5 (1 - 26)
27
– 52
X9 (1 - 26)
131
– 156
X6 (1 - 26)
53
– 78
X10 (1 - 26)
157
– 182
X7 (1 - 26)
79
– 104
X11 (1 - 26)
183
– 208
Table 18. MCU pin Headers, X4-X11
5.6 Video Jack (X12)
The video jack is a standard RCA socket for composite video signal input. The centre of the
connector X12 is connected to JP15 which can (see section 4.12) direct this signal to the
MCU pin VIN (pin 205). The outer shield is connected to GND. The following picture shows
the connections of X12.
5.7
CAN ‘A’ connector (X13)
The connector of CAN ‘A’ is a male 9-pin D-Sub connector. CANH is connected to pin 7 and
CANL is connected to pin 2. Pin 3 is connected to GND.
X13 pin no.
Signal
1
n/c
2
CANL
3
GND
4
n/c
5
n/c
Figure 4: Video Jack X12
Shield: Ground (GND)
Centre: Video Signal
Figure 5
: CAN ‘A’ connector
