58
Options Guide
TX300 S5
HDD extension box
Accessible drives
©
c
o
gn
it
a
s
. Ge
s
e
lls
c
h
ft
f
ü
r T
e
c
h
ni
k
-D
o
k
u
m
ent
a
ti
o
n m
b
H
2
0
0
9
P
fad
: C
:\
P
ro
gram
m
e
\F
CT
\t
im
_ap
p\
ti
m
_
lo
c
a
l\
wo
rk
\J
E
S
U
S
\O
B
J
_
D
O
K
U
-4
3
3
4
-0
0
2.
fm
6.4
HDD extension box
In the base units two 5.25-inch bays for accessible drives can be used to install
a HDD extension box.
Two variants of the HDD extension box are available:
●
HDD extension box for 3.5-inch HDD modules (Multibay 2):
Multibay 2 contains one bay for a LSP or LSD, one bay for a DVD drive, and
two bays for 3.5-inch HDD modules.
●
HDD extension box for 2.5-inch HDD modules:
This HDD extension box contains eight bays for 2.5-inch HDD modules.
The HDD extension box is supplied without EasyClick rails. You need 4 M3
screws. Before installing a new HDD extension box you must therefore remove
the EasyClick rails from one dummy cover and mount two EasyClick rails on the
HDD extension box.
Ê
Remove the dummy covers from the required 5.25-inch bays (see section
"Equipping of the bays" on page 41
and section
).
Ê
Detach the EasyClick rails from a dummy cover by removing the four screws
on each side (see figure
I
Note that there are two M3 screws and two UNC screws on each side
V
CAUTION!
Keep the dummy covers for future use. If you remove the HDD extension
box again and do not replace it with a new one, the dummy covers must
be reinstalled to comply with EMC regulations and to satisfy cooling
requirements and fire protection measures.
