Fujitsu Primergy TX300 S4, Руководство пользователя

Страница: 35 / 276

35
PRIMERGY TX300 S4 User's Guide
1
Slide the drive cover.
J
"1.4.1 Sliding the Drive Cover" (pg.31)
2
Make sure that the floppy disk drive and CD/DVD drive are empty.
3
Turn on the display and peripheral devices.
4
Press the power switch on the front of the server.
The server's power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed ("8.2.2 Error Messages"
(
J
pg.224)).
` The time to turn off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's Guide".
` If you press the [F12] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ("
„
How to start BIOS Setup Utility" ( J pg.193)).
1.4.4 Turning Off the Server
1
Slide the drive cover.
J
"1.4.1 Sliding the Drive Cover" (pg.31)
2
Make sure that the floppy disk drive and CD/DVD drive are empty.
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so may lead to a fire or electric shock.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
This server's
LED is lit green.