Fujitsu PRIMERGY TX2550 M4, Руководство по модернизации и обслуживанию, Страница: 122 / 563

122
Upgrade and Maintenance Manual TX2550 M4
Basic software procedures
Ê
Enter the BIOS.
Ê
Select the Advanced menu.
Ê
Select the status menu of the desired component:
– CPUs: CPU Status
I
This option is only available for multi-processor systems.
– Memory: Memory Status
– Expansion cards: PCI Status
Ê
Reset replaced components to Enable .
Ê
Save your changes and exit the BIOS.
I
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
5.2.10 Verifying the memory mode
If a memory module fails, the server will reboot and the defective module will be
disabled. As a result, the current operation mode (e.g. Mirrored Channel mode)
may no longer be available due to a lack of identical memory module pairs. In
this case, the operation mode will automatically revert to Independent Channel
Mode.
I
For more information on memory operation modes available for your
server, see section
"Modes of operation" on page 349 .
After replacing the defective module(s) the memory operation mode is
automatically reset to its original state. It is recommended to verify that the
operation mode has been correctly.
Ê
Enter the BIOS.
Ê
Select the Advanced menu.
Ê
Select Memory Status and verify that none of the memory modules are
marked as
Failed
.
Ê
Select Memory Configuration to verify Memory Mode of Operation .
Ê
Save your changes (if applicable) and exit the BIOS.
I
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.