Fujitsu Primergy TX120, Руководство пользователя

Страница: 131 / 263

131
PRIMERGY TX120 User’s Guide
5
Operatio
ns
a
fter OS In
st
al
lation
5.3 Storing the System Configuration
Information
Before starting operations and when changing the system configuration information,
store the configuration information. By storing this information, the system can be
recovered with the stored information in case of a system failure (such as when the
baseboard fails). Use Server Management Tools for storing and recovering the
system configuration information.
`
Since the system configuration information is significant in maintaining the server, be sure to store the
configuration information after the following operations:
• When the information is changed with the BIOS Setup Utility
• When the hardware configuration of this server is changed (e.g. CPU, memory, baseboard or
expansion card is added/removed or changed)
• When the Remote Management Controller information is changed
` As the stored system configuration information will be used for maintenance operation.
` When starting the server without setting the floppy disk in the FDD unit (USB), BIOS does not
recognize the FDD unit (USB). Make sure to connect the FDD unit (USB) and set the floppy disk
before starting the server. For details, refer to "E External Floppy Disk Drive (USB) Notes on Usage"
(
J pg.257).
„
Cautions
• "Server Management Tools" disk is exclusively for this server. Do not use it on other systems.
Otherwise, the systems may be damaged.
• Only the information that is configured with the BIOS Setup Utility and the configuration
information of the Remote Management Controller can be stored/recovered. However, a user account
for the Remote Management Controller and the license information of the Remote Management
Controller Upgrade Kit cannot be stored.
• Make sure to perform this operation only when the server is started with the "Server Management
Tools" disk. Do not run Server Management Tools on the server started from the hard disk or by the
other floppy disk. Otherwise, the system may be damaged.
• Do not eject a floppy disk while the floppy disk access LED is on. Such an action may lead not only
to corruption of the floppy disk data but also an unstable state of the system.
• If an error message appears while running Server Management Tools, respond to the message
according to "
„
Server Management Tools Error Messages" ( J pg.221).