Fujitsu Primergy RX300 S3, Руководство пользователя

Страница: 32 / 313

32
Chapter1 Overview
1.4.2 Turning On the Server
1
Open the rack door.
2
Make sure that the floppy disk drive and CD-ROM drives are empty.
3
Turn on the display and peripheral devices.
4
Press the power switch on the front of the server.
The server's power LED is lit green. When the power is turned on, the server performs Power On
Self Tests (POST). If any abnormalities are detected by POST, error messages are displayed.
"9.2.2 Error Messages" (pg.260)
The time to turn on/off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server.
For details, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's Guide" on the
PRIMERGY Document & Tool CD.
It may take a few seconds until the server to power on after pressing the power switch.
• Do not move, strike, or shake the server when it is turned on. This can damage
the hard disk in the server and cause data loss.
• Turn the server on when the temperature is in its operating environment range
(10-35
°
C). For details on the operating environment, refer to "Start Guide" and
"Safety Precautions".
When operating the device outside of this operating environment, the server
may operate improperly, damage data etc.
Furthermore, Fujitsu cannot be held responsible for any related damage,
malfunction, or loss of data, etc.
• Be sure to wait for 10 seconds or more after shutdown before turning the
server on.
Power switch
The server's power
LED is lit green