Fujitsu PRIMERGY RX2450 M1, Руководство по модернизации и обслуживанию, Страница: 72 / 246

interface card in the related NIC configuration file of the Linux OS. When
replacing a network controller or the system board with onboard LAN
controllers in a server running Linux OS, the MAC address will change but not
automatically be updated in the definition file.
In order to prevent communication problems, it is necessary to update the
changed MAC address stored in the related
ifcfg-eth<x> definition file.
Procedures may differ depending on your Linux OS or the definition file
on the client system. Use the following information as reference. Ask the
system administrator to change the definition file.
To update the MAC address, proceed as follows:
▶
After replacing a network controller or the system board, switch on and boot
the server, see
"Switching on the server" on page 49 .
The hardware configuration tool for Red Hat Linux, will launch at boot and
detect the new and/or changed hardware on your system.
▶
For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
If the system board or network controller offers multiple LAN ports, it
is necessary to update the remaining
ifcfg-eth<x> definition files
accordingly.
▶
Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.2.6 Performing a RAID array rebuild
After replacing an HDD that has been combined into a RAID array, RAID
rebuild will be performed completely unattended as a background process.
▶
Ensure that the RAID array rebuild has started normally. Wait until the
progress bar has reached at least one percent.
▶
Inform the customer about the remaining rebuild time, based on the
displayed duration estimate.
Basic software procedures
72 Upgrade and Maintenance Manual RX2450 M1