Fujitsu Primergy RX100 S3, Руководство пользователя

Страница: 33 / 287

33
PRIMERGY RX100 S3 User’s Guide
1
Overview
1.4.3 Turning Off the Server
1
Make sure that the CD-ROM drives are empty.
2
Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 3 is not necessary).
• Windows OS
• When ServerView is installed
In other cases, shut down the OS and make sure that hard disk access LEDs are off.
3
Press the power switch at the front of the server.
The server's power LED turns amber.
4
Turn off the display and peripheral devices.
The time to turn off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server. For details, refer to "3.2 Settings for Server Monitoring" in
"ServerView User's Guide" on the PRIMERGY Document & Tool CD.
If you press the [F8] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ( "
■
How to Start the BIOS Setup Utility" (pg.202)).
• In the event of smoke or sparks, immediately unplug the power plug from the
outlet. Failure to do so may lead to a fire or electric shock.
• When turning off the server, be sure to follow the procedures described in this
section. Data may be lost if these procedures are not followed correctly.
• Be sure to wait for 10 seconds or longer after shutdown before turning the
server on.
Power switch
The server’s
power LED
turns amber