U41147-J-Z156-2-76
99
Appendix
Removing the cage for the hard disk drives
10.2
Removing the cage for the hard disk drives
Ê
Shut down the operating system, switch off the server, and disconnect it
from the main power supply.
V
CAUTION!
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Ê
Open the server, and remove the front doors, the top cover, the side cover,
and the slot cover (see chapter “Opening and closing the server” on
page 47).
Ê
Remove the front panel (see section “Removing/mounting the front panel”
on page 98).
Ê
Disconnect the SCSI cable from the SCSI B connector on the system board
(see documentation of the system board).
Ê
Remove all hard disk drive modules from the server (see section
“Installing/removing SCSI hard disk drives” on page 68).
V
CAUTION!
All of the hard disk drives must be uniquely identified so that you can
reinsert them into their original bays; otherwise, existing data may be
destroyed.
Содержание PRIMERGY H200
