Fujitsu PRIMERGY 300, Руководство по эксплуатации

Страница: 20 / 94

Preparation for use and operation
12
A26361-K423-Z202-3-7619
Preparing the PC for use
When you set up the server for the first time, you should carry out the following
steps in the order shown. Unless otherwise specified, the steps are described in
this chapter.
1. Decide where you are going to install the server.
2. Connect the external devices to the server.
3. Check the rated voltage and connect the server to line voltage.
4. Switch the server on and follow the instructions on the screen.
Setting up the server
!
When installing your server, give consideration to the recommendations
about an ergonomic video workstation in the "Safety and ergonomics"
manual.
We recommend that you place your equipment on a surface with good
anti-slip qualities. In view of the multitude of different finishes and
varnishes used on furniture, it is possible that the rubber or aluminum feet
of the devices will mark the surface they stand on.
Do not expose the server to extreme environmental conditions (see
chapter "
Technical data "). Protect it from dust, humidity and heat.
Provide at least 200 mm of clearance in front of and behind the ventilator
area of the server to ensure adequate ventilation. Do not cover the
ventilation areas of the monitor and the server.