Fujitsu PRIMEQUEST 1000 Series, Руководство по установке

Страница: 303 / 344

TABLE E.2 IP addresses to be set for virtual ports
Partition number IP address Subnet mask
0 172.30.0.2 255.255.255.0
1 172.30.0.3
2 172.30.0.4
3 172.30.0.5
<Example with the partition number of #2 and the PSA-MMB port group of vswif1>
# esxcfg-vswif –a vswif1 -i 172.30.0.4 -n 255.255.255.0 \
-p PSA-MMB
# esxcfg-vswif -l
Name Port Group/DVPort IP Family IP Address \
Netmask Broadcast Enabled TYPE
vswif0 Service Console IPv4 192.168.0.2 \
255.255.255.0 192.168.0.255 true STATIC
vswif1 PSA-MMB IPv4 172.30.0.4 \
255.255.255.0 172.30.0.255 true STATIC
\: This indicates that there is no line feed.
5. Add the following setting to the PSA-to-MMB communication LAN:
Speed: 100 Mbps
Duplex: full
<Example with the PSA-to-MMB communication LAN of vmnic0>
# esxcfg-nics vmnic0 -s 100 -d full
6. Set the PSA-to-MMB communication LAN IP addresses in the PSA configuration file.
File storage location : /etc/opt/FJSVpsa/usr/tommbipsetup.conf
Setting values: Enter the IP addresses set in Step 4.
<Setting example>
[NETWORK]
TOMMBIP=172.30.0.4
The configuration work is completed through the above steps.
In the above configuration example, the network is configured as follows:
PRIMEQUEST 1000 Series Installation Manual
APPENDIX E Notes on VMware Installation
275 C122-E107-09EN