E-2
INFORMATION
• Receptacle
Make sure that the power cable’s grounding wire is grounded.
The display comes with a 3-prong power plug; one prong is connected to the grounding wire. If you have only a 2-hole receptacle, you
will need to have it replaced. Contact your dealer for more information.
• Have the display inspected and cleaned by your dealer at regular intervals.
• Pictures may become “burnt” into the screen phosphors if the screen is left on for extended periods. To ensure that the display has a
prolonged service life, be sure to use a screen orbiter, white screen. This will ensure the same picture or pattern is not constantly
displayed for long periods.
• Extremely high-precision technology has been used in the manufacture of the plasma display panel, with the effective pixel elements
exceeding 99.99%. Please be aware, however, that fewer than 0.01% of the pixels may be missing or remain constantly lit.
• Some models are fitted with a radiator fan to prevent the display’s internal temperature from rising during operation. Be careful of the air
emitted by the radiator fan, as it may be hot.
• Contact your dealer if you find that the display does not seem to function properly when used with other audio-visual equipment.
You may need to move your display if it produces degraded pictures or noise due to electromagnetic radiation, or if the infrared remote
control does not function properly.
• Pictures may not be displayed properly if you connect a non-standard PC to the RGB input terminal. In this case, contact your dealer for
more information.
• The protective circuit, built into the display, automatically turns off the power if the display has a problem. In this case, you will see that
the power indicator lamp flashes red or green.
• Install the display in a location close to a main power supply outlet, and where the emergency stop button can be easily reached.
/I power switch
• When pressed while in the “OFF” state, the power indicator lamp lights and the display is placed in the “ON
” state, and the power can
be turned “ON” or “OFF” by the remote control or on the control panel of the display. When pressed while in the “ON
” state, the
power indicator lamp goes out and the display is placed in the “OFF” state where power is still partly supplied.
Warning
If the power indicator lamp flashes red or green, this signifies that the display has developed a problem. When this happens, be sure to remove the
power plug from the receptacle to prevent fire or electric shock. Then contact your dealer.
Note
• Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.
• In order to facilitate the explanations, pictures and diagrams in this manual may differ slightly from the actual items.
MHD01679_E.book 2 ページ ２００５年１月１４日 金曜日 午前９時５２分
