Fujitsu M3097G, Руководство OEM

Страница: 113 / 163

4.5 Status: STATUS phase (target Æ initiator)
Each time a command is terminated, the target moves into the STATUS phase and
returns a status byte to the initiator to report the completion of the command.
Status byte
Byte 0 Status byte code (Reserved)
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
7
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
6
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
5
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
4
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
3
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
2
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
1
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
0
(Reserved)
The status supported by this scanner are summarized in the following table.
Code Status of unit
000000 GOOD
f The command has successfully terminated.
000001 CHECK CONDITION
a) The command has abnormally terminated.
b) An abnormal condition was detected before a unit is selected.
f The target detected an error before start of command
>
controlled
processing.
f A unit that switched from the NOT READY status to the READY
status was selected for the first time.
f A unit that received a RESET CONDITION or a BUS DEVICE RESET
message was selected for the first time.
00100 BUSY
A target or logical unit cannot accept a new command.
f The logical unit is executing processing.
f The target is executing processing on a specified logical unit or other
logical unit.
f The target intends to report to an other initiator the sense data of a
specified logical unit.
f The target intends to report to an other initiator the sense data of a logical
unit that was not specified.
f The target intends to report the status to any initiator.
01100 RESERVATION CONFLICT
f The specified unit is already reserved by another initiator.
When a target is released from the BUSY status, it will not issue a notification of the
release. Therefore, the initiator needs to check the status of units periodically and needs to
issue the command again.
4 $ 88