Fujitsu M3096NT, Руководство оператора, Страница: 137 / 147

7 – 1
Possible cause
The power switch was not
turned on.
The power cable was not
connected correctly.
——————————
The documents were not
placed on the ADF correctly.
The ADF was not closed
completely.
The interface cables were not
connected correctly.
Halftone processing was not
selected.
The document bed, docu-
ment holding pad, or inside
ADF is dirty.
Simple binarization was not
done.
The document bed, docu-
ment holding pad, or the
inside of the ADF is dirty.
The document was moved
during the read operation.
The document was not in
contact with the glass.
CHAPTER 7 TROUBLESHOOTING
If a problem occurs, use Table 7.1 to resolve the problem.
Problem
No power
Read operation
does not start.
Pictures and
photographs are
not read cor-
rectly.
Characters and
lines are not
read correctly.
Image is dis-
torted or un-
clear.
Response
Press the power switch.
Connect the power cable correctly.
Turn off the power once and make an
attempt to turn on the power again. If the
power is not turned on, contact your
Fujitsu service representative.*
Insert the first a few pages into the slot.
Make sure that the ADF is closed com-
pletely.
Connect the terminator.
Select a halftone mode from the host
system.
Clean the dirty parts as explained in
Section 6.3, “Cleaning.”
Select a binarization mode from the host
computer.
Clean the dirty parts as explained in
Section 6.3, “Cleaning.”
Keep the document cover closed during
reading so that the document will not be
moved.
Adjust the document so that it is in
contact with the glass.
Table 7.1 Check items