1
Connecting power to the switch
Power down all servers that will be part of your
switching system. Locate the power cord that came with
the switch. Plug one end into the power socket on the
rear of the switch. Plug the other end into an appropriate
AC wall outlet.
2
Connecting the local port.
Plug your VGA monitor, PS/2 or USB keyboard and mouse
cables into the appropriately labeled switch ports.
3
Connecting a KVM-IA to the switch
Choose an available port on the rear of your switch. Plug
one end of a CAT 5 cable (4-pair, up to 10 meters) into
a numbered port and plug the other end into the RJ-45
connector of a KVM-IA.
4
Connecting a server to the KVM-IA
Plug the KVM-IA into the appropriate ports on the back
of the server. Repeat this procedure for all servers that
are to be connected to the switch.
5
Connecting network and remote users
Plug a CAT 5 cable from your Ethernet network into the
LAN connector on the back of your switch. Network
users will gain access through this port.
6
Connecting local virtual media
(optional)
Connect virtual media devices to any of the four USB
ports on the switch.
7
Powering up targets and switch
Power up each target server and then power up the
switch.
NOTE: To open a virtual media session with a server, the
server must
fi
rst be connected to the switch using a virtual-
media capable KVM-IA. (KVM s3-Adapter USB2-VGA).
For additional information
For further instructions on switch connection, software
setup and security con
fi
guration, please refer to the
installer/user guide included with the switch. Check
http://www.fujitsu.com for the latest switch software and
fi
rmware updates.
Quick Installation Guide
Fujitsu Technology Solutions GmbH, User Documentation, 33094 Paderborn, Germany • Email - [email protected] • Online - http://ts.fujitsu.com/support
All hardware and software names used are trademarks of their respective manufacturers.
590-592-609B
installation
2
KVM s3-1621
The following instructions will help you install
and use your KVM s3-1621 .
Should you require further assistance, please
consult your installer/user guide.
1
Power down all
servers and attach
the appropriate
power cord to the
switch.
2
Plug in the keyboard,
monitor, mouse and USB
connectors for your local
connection.
3
Connect KVM-IA
adapters to the
switch.
4
Connect servers to the
KVM-IA adapters.
5
Connect the switch to
the network.
KVM s3-1621
Local Connections
Server
Server
Server
Server
