Chapter 8 Operational Settings
173
3
Select a paper protection detection method which you
want to change the sensitivity level for.
Feeding Accuracy: Select this to detect a document that is unusually
warped when a feeding error occurs.
This is available when you have selected [Feeding
Accuracy] or [Feeding Accuracy & Noise] for the
paper protection detection method.
Feeding Noise: Select this to detect paper jam noise.
This is available when you have selected [Feeding
Noise] or [Feeding Accuracy & Noise] for the paper
protection detection method.
4
Specify the sensitivity level.
Low: Decreases the sensitivity level to detect warped documents or
paper jam noise.
Normal: Monitors warped documents or paper jam noise with normal
sensitivity.
Keep this setting for normal use.
High: Increases the sensitivity level to detect warped documents or
paper jam noise.
Low-speed Scan at Lower Resolution
(Low-speed Feed Mode)
When scanning at a lower resolution (less than 400 dpi), you
can configure the scanner to scan documents slowly
regardless of the resolution setting.
Scanning documents slowly can prevent the documents from
being damaged.
This setting is effective when you scan long page documents.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
2
From the listing on the left, select [Device Setting 2]
[Low-speed Feed Mode].
3
Select whether to disable or enable [Low-speed Feed
Mode].
HINT
To detect paper warp or paper jam noise faster and stop the
scan, select [High].
To decrease the frequency of paper jam detection if paper jams
occur frequently in the feeder, select [Low].
This setting can also be configured with the operator panel.
When the operator panel setting is prioritized, the operator
panel setting is prioritized over the Software Operation Panel
setting.
HINT
This setting can also be configured with the operator panel.
