Fujitsu FI-400F, Руководство оператора

Страница: 19 / 96

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
19
How to Scan
Documents
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
How to Use the
Operator Panel
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes (factory default
setting) without being used, it automatically enters power
saving mode.
The Power indicator remains lit in power saving mode.
To resume from power saving mode, perform one of the
following:
 Press the [Scan/Stop] button on the operator panel.
 Perform scanning from an application.
The scanner is turned off automatically if it is left on for a
certain period of time without being used, reducing the power
consumption until the next scan.
To prevent the scanner from being turned off automatically,
clear the [Power off after a certain period of time] check box in
[Device Setting] on the Software Operation Panel. For details,
refer to
"Waiting Time to Enter Power Saving Mode [Power
saving]" (page 79) .
To turn the power back on after the power is turned off
automatically, press the [Power] button on the operator panel.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
17) .
1.5 Power Saving Mode
ATTENTION
 When the scanner performs scanning for the first time after it
resumes from power saving mode, the same initialization as power-
on is performed.
 For some applications, the scanner may not be turned off even if the
[Power off after a certain period of time] check box is selected.
 If the scanner is automatically turned off while you are using an
image scanning application, exit the application before turning the
scanner back on.
HINT
 The time specified before entering power saving mode can be
changed in the Software Operation Panel.
For details, refer to "Waiting Time to Enter Power Saving Mode
[Power saving]" (page 79) .
 For details about the operator panel, refer to "Chapter 3 How to Use
the Operator Panel" (page 27) .