Fujitsu ETERNUS DX8100 S3, Руководство по планировке объекта

Страница: 78 / 81

Installable Racks
This section explains the racks in which the ETERNUS DX can be installed.
Fujitsu Racks
The ETERNUS DX can be installed in a Fujitsu 19-inch rack. For information about whether the ETERNUS DX can
be installed in an EOLed rack or not, contact your sales representative.
Non-Fujitsu Racks
The ETERNUS DX storage systems are developed and their operation is guaranteed on the assumption that they
are installed in Fujitsu 19-inch racks. Since the ETERNUS DX cannot be tested (for cooling and strength) in non-
Fujitsu 19-inch racks, the operations of ETERNUS DX storage systems cannot be guaranteed. Any problem that
may occur by installing the ETERNUS DX in non-Fujitsu racks is not covered by the warranty.
If the ETERNUS DX needs to be installed in a non-Fujitsu rack, the following conditions must be satisfied.
■
Rack Specifications
Use the rack mount kit supplied with the product to install the ETERNUS DX in the rack. The rack specifications
must satisfy the conditions listed below. For rack specifications, refer to the manual for the rack that is used.
•
Pitch for mounting holes
EIA Standard Universal pitch
• Size for mounting holes
The size of the square holes must be 9mm or more.
•
Load bearing capacity
The load bearing capacity must be equal to or larger than the total weight of the ETERNUS DX.
• Unit Installation Area
The dimensions of the area shown in
Figure 54 must match the conditions described in Table 33 .
2. Rack Installation Specifications
Installable Racks
78
FUJITSU Storage ETERNUS DX8100 S3/DX8700 S3/DX8900 S3 Hybrid Storage Systems Site Planning Guide
Copyright 2020 FUJITSU LIMITED
P3AM-9422-13ENZ0