Fujitsu Eternus DX200F, Руководство пользователя

Страница: 974 / 1082

Appendix B Factory Default List
B.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
974
For the controller firmware version V10L30 or later
*1: Because the default setting is "Enable", only the [Stop] button is displayed.
*2: Because the default setting is "Disable", only the [Start] button is displayed.
■ Setup Power Management
■ Setup Extreme Cache
Screen Setting item Default value
Set SMI-S Current Status
•
When the ETERNUS DX is shipped to EMEA
region
Enable (*1)
•
When the ETERNUS DX is shipped to regions
other than EMEA
Disable (*2)
Screen Setting item Default value
Power Control by External
Device RCIL Disable
Auto Power Disable
Power Resume Disable
PWC Connection Settings Connection CM Cleared
Connection SVC Cleared
Delay until Shutdown 0 min.
Set management unit
interface
•
For the ETERNUS DX8700 S3/DX8900 S3
Manual
•
For the other models
PMAN
Power Failure Signal Positive
Low Battery Signal Positive
UPS Shutdown Signal
•
Cleared
•
When the "Enable" checkbox is selected
"Positive"
Screen Setting item Default value
Extreme Cache Setting Cache Used Not Used
Extreme Cache Memory Size
Setting New Memory Size 0 (GB)
Extreme Cache Pool Memory
Size Settings Select Drives All cleared
Encryption by CM Off
Tuning Parameters Settings Initial Caching Threshold 1
Caching Threshold
•
5
•
"Not replace Cache Data" checkbox
Cleared (relocate)
Caching Priority 10 (Fastest)
Monitoring I/O Read