Fujitsu Eternus DX200F, Руководство пользователя

Страница: 842 / 1082

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
842
• Checkbox to select a port
A.4.3.6 Modify FC Port Parameters
For details about this function, refer to "4.3.7 Modify FC Port Parameters" (page 441) .
For the factory default settings for this function, refer to the following sections:
• "Appendix B Modify FC Port Parameters (when the port mode is "CA")" (page 994)
• "Appendix B Modify FC Port Parameters (when the port mode is "RA" or "CA/RA")" (page 994)
• "Appendix B Modify FC Port Parameters (when the port mode is "Initiator")" (page 995)
●
Port Settings
• Port
• Connection
Description The checkbox of the port, which has been registered in the CA port group, is selected.
Select the port checkbox to be added to a CA port group. Clear the port checkbox to be
deleted from a CA port group.
Input condition/
Display contents Checkbox
•
Selected
•
Cleared
•
If the CA port group's affinity mode is "On" (the affinity mode of all the selected ports is "On"), the port, of which
affinity mode is "OFF", cannot be selected.
•
If the CA port group's affinity mode is "Off" (the affinity mode of all the selected ports is "Off"), the port, of which
affinity mode is "On", cannot be selected.
•
Up to eight ports can be selected.
Description Select the target port or select the copy source port.
The selectable port locations (x: CE number, y: CM number, z: CA number, w: Port num-
ber) are displayed as options.
Input condition/
Display contents
•
For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
•
For the other models
CM#y CA#z Port#w
Description Select the connection type for the target port.
When "FC-AL" is selected, it is necessary to assign a Loop ID to the port.