Fujitsu ETERNUS DX Disk, Руководство по настройке

Страница: 34 / 85

2.3.3 Creating a Target Binding Table
This procedure is not necessary for direct connections.
Target binding logically binds the Fibre Channel card installed in the server, and the CA on the ETERNUS
DX/AF storage systems to be connected to the server.
Target binding binds the instance name of the Fibre Channel card, channel adapter name, WWN, and target
ID.
Enter the required information for target binding in the "target binding table". Create "Target binding tables"
for each server to be connected.
Enter the following information in the target binding table.
•
Name of target server
• Channel Adapter names and their SCSI target IDs
The "channel adapter names" and "target IDs" entered in the "WWN instance management table for stor-
age system"
•
RAID-WWN
The WWN entered in the "WWN instance management table for storage system"
1
Enter the target information to be set for the server.
Reflect the information from the "WWN instance management table for storage system" in the "target
binding table".
Target Binding Table
Server name: Server1
Channel Adapter name SCSI T-ID RAID-WWN Instance name
CM0CA0 16 202000c000cb0001
CM1CA0 16 203000c000cb0001
2
Confirm the connection path(s) in the system.
Example:
Server#0
Slot0 Slot1
CA0 Port0
CM0
CA0 Port1
ETERNUS DX/AF
Fibre Channel Switch A Fibre Channel Switch B
CM1
CA0 Port1 CA0 Port0
Physical slots on Server#0 and CAs on the ETERNUS DX/AF storage systems are connected in the follow-
ing paths.
• Server#0 SLOT0 - CM0CA0
•
Server#0 SLOT1 - CM1CA0
Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.3 Setting Up the Server
34
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0